Pushes a profile out along a direction to make a solid of the given length. Options taper the walls, center the solid on the profile plane, or make it a thin-walled tube following the profile's outline.
The flat outline to extrude.
Wired extrusion length; takes precedence over the typed value.
Wired extrusion direction; takes precedence over the typed value.
Wall taper in degrees, from -89 to 89. 0 gives straight walls; positive values lean the walls inward. Distances are approximate at steep angles.
When on, the solid reaches half the distance to each side of the profile plane.
When above 0, only a wall of this thickness in mm along the outline is extruded, leaving it hollow. Wire a field for a varying wall.
For a hollow extrusion: Inward keeps the outline as the outer face, Outward as the inner face, Center puts half the wall on each side.
Values the block gives besides its output. The editor lists them under Properties, and an input can read one by reference.
The axis-aligned extent of the Solid.
The Solid's signed distance, as a field.
The Solid turned inside out: what was inside is now outside.